| |
User Guide
|
SRC 200  |
|
*** NOTE *** If you have the same TV but are programming a new remote, then you need to follow steps A,B, & C. Or, if you have a new TV but are using the same remote then you just need to do step C.
Remote Instructions for SRC - 200 NEP Remote
|
A | Set Gateway ID:
- Point Remote at the Gateway.
- Press B button until red LED flashes.
- Press 7, 8, 9
- Enter 3 digit Gateway ID number. See How to get Your Gateway ID at the bottom of this page if it's not on the front of your Gateway.
- Get flashing LED.
|
B | Set Remote Signal:
- Point Remote at the Gateway.
- Press A button until red LED flashes.
- Press 7, 8, 9
- Press 0, 1, 2 or 3 refer to RCID chart.
- Get flashing LED.
|
C | Set Remote for TV:
- Turn on TV.
- Point Remote at TV
- Press Mute until red LED flashes.
- Press power.
- Arrow up until TV goes off.
- Press Select.
- Get flashing LED.
|
Click here to download and install Adobe Reader 
How To Get Your Gateway ID:
- Check the Front of Gateway for ID. Some Gateway's have the ID on the front or side. If no ID is found go to step 2.
- Press Menu or "Wrench" button on Gateway.
- Arrow down to remote control setup.
- Press select.
- Press PPV.
- Gateway ID will appear on channel 3 TV 1
- Get ID then exit.
|
Back to DataVision