The North-Eastern Pennsylvania Telephone Company

Call Us Toll Free: 1-866-785-3131
 

   Support Desk > DataVision

Back to DataVision Rates & Plans Back to DataVision
NEP Remotes

   User Guide

SRC 350

*** NOTE *** If you have the same TV but are programming a new remote, then you need to follow steps A,B, & C. Or, if you have a new TV but are using the same remote then you just need to do step C.

Remote Instructions for SRC - 350 NEP Remote

A | Set Gateway ID:

  1. Point Remote at the Gateway.
  2. Press and hold Select and Mute together until LED flashes.
  3. Press B button.
  4. Enter 3 digit Gateway ID number. See How to get Your Gateway ID at the bottom of this page if it's not on the front of your Gateway.
  5. Get flashing LED.

B | Set Remote Signal:

  1. Point Remote at the Gateway.
  2. Press and hold Select and Mute together until LED flashes.
  3. Press A button.
  4. Press 1, 2, or 3 refer to RCID chart.
  5. Get flashing LED.

C | Set Remote for TV:

  1. Turn on TV.
  2. Point Remote at TV
  3. Press and hold Select, then press and hold Mute together until LED illuminates. Release both buttons.
  4. Arrow Up slowly until TV goes off.
  5. Press Select.
  6. Get flashing LED.

* If TV Does not turn on repeat Step C but Arrow Down Slowly until TV turns off. Continue 5 & 6.

Click for Printer Friendly View

Click here to download and install Adobe Reader


How To Get Your Gateway ID:

  1. Check the Front of Gateway for ID. Some Gateway's have the ID on the front or side. If no ID is found go to step 2.
  2. Press Menu or "Wrench" button on Gateway.
  3. Arrow down to remote control setup.
  4. Press select.
  5. Press PPV.
  6. Gateway ID will appear on channel 3 TV 1
  7. Get ID then exit.

NEP Home ‌ Mission / Vision Statement ‌ PUC Rates and Rules Tariff ‌ Customer Rights ‌ Repair Policies
Customer Service Agreement ‌ Internet User Agreement ‌ Acceptable Use Policy ‌ Long Distance
Residential ‌ Business ‌ Internet DSL ‌ Internet Dialup ‌ DataVision ‌ LSP Migration